300 RPM Johnson Gear DC Motor 12V For Arduino/Raspberry-Pi/Robotics300 RPM Johnson Gear DC Motor 12V For Arduino/Raspberry-Pi/RoboticsRs.347.46
BO (Battery Operated) light weight DC geared motor which gives good torque and rpm at lower voltages. This motor can run at approximately 100 rpm when driven by a single Li-Ion cell. Great for battery operated light weight robots. It can do reverse and forward directions.
- Working Voltage 3-12V
- No Load Speed: 100rpm /- 10rpm
- No Load Current: 125mA (max.170mA)
- Torque: 600gf.cm min 40gm weight
- Microcontroller ATmega328P
- Operating Voltage : 5V
- Digital I/O Pins 14 (of which 6 provide PWM output)
- PWM Digital I/O Pins 6 Analog Input Pins 6
- Flash Memory 32 KB (ATmega328P) of which 0.5 KB used by bootloader
The Bluetooth Module Breakout is the latest Bluetooth wireless serial cable! This version of the popular Bluetooth uses the HC ? 05 / 06 modules. These modems work as a serial ( RX / TX ) pipe. Any serial stream from 9600 to 115200 bps can be passed seamlessly from your computer to your target. The remote unit can be powered from 3.3 V up to 6 V for easy battery attachment. All signal pins on the remote unit are 3 V ? 6 V tolerant. No level shifting is required. Do not attach this device directly to a serial port. You will need an RS232 to TTL converter circuit or Arduio XBee USB Adapter if you need to attach this to a computer. You can either solder a 6-pin header or individual wires. Unit comes without a connector. Please see related male and female pins below. And now, we provide HC-05/06, HC-06 / 05 could be setting to Master or Slave by user. HC-06 just is Master or Slave that could be customized. This module default is HC-06 with Slave mode. Note: Be paired must Master devices and Slave devices each other. Master and Master devices, Slave and Slave devices can’t pair each other. The HC – 06 ( just supply slave mode and more easy ) Slave mode could paired with PDA, PC etc.
- About Us
- PROJECTS & WORKSHOPS
- Air Shows
- Contact Us